CrimeStopper CS-2000DPII Betriebsanleitung

CS-2000DPII TW2 With 2-Way Data Port Technology 2-WAY REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGR

10 OPTION PROGRAMMING 1. Turn the Ignition ON and press the Override/Program button 5 times. 2. After a short delay, the parking lights will flash

11 OPTION PROGRAMMING NOTE: Options can be instantly restored to Factory Default Values. To restore default values: Perform step #1 (See page 1

12 OPTION PROGRAMMING 6. ACTIVE RE-ARMING Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a d

13 OPTION PROGRAMMING Cont. 14. CARJACK FEATURES This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with

14 OPERATING INSTRUCTIONS (REMOTE OPERATIONS) ONE WAY SIDEKICK REMOTE: The transmitter supplied with the CS-2000DPII-TW2 system has four buttons.

15 BUTTON 5 (On side of remote): • Press and release to light up the LCD screen. • Press and release twice to recall the last message from

16 1ST AUX. OUTPUT TRUNK POP (FLASH) (OR HOOD OPEN) OPERATION INSTRUCTIONS (LCD PANEL

17 OPERATION INSTRUCTIONS ACTIVE ARMING To arm the alarm and lock the doors, press the #1 (Lock Symbol) button on the transmitter. You will hear a

18 OPERATING INSTRUCTIONS SELECTIVE SILENT ARM/DISARM THROUGH REMOTE CONTROL This system can be armed and disarmed without siren chirps on an “

19 OPERATING INSTRUCTIONS PRIOR INTRUSION ALERT If the system was tripped in your absence, the dash LED will be flashing rapidly. W

2 TABLE OF CONTENTS Installation Cautions & Warnings..…….……………………………….……………………………………….……2 Control Module & Component Mounting ……………...……………

20 CARJACK PROTECTION FEATURES ACTIVE CARJACK This feature provides Active Carjack protection and must be enabled before use through Alarm programmi

21 ANTENNA DIAGRAM WINDSHIELDANTENNALOCATIONSBlack PlugWhite PlugRECOMMENDEDTransceiver Box & AntennaCS-2000DPII-TW2 Antenna SystemCS-2000DPII-

22 WIRING DIAGRAM +-+REDWHITEBROWNBLUE/WHITEWHITE/REDORANGEBLACK/WHITEBLUEGRAYYELLOWBLACKVIOLETGREENLEDOVERRIDE/PROGRAMBUTTONBATTERY(-) LOCK OUTPUT+1

23 LOW BATTERY WARNING – LCD REMOTE LOW BATTERY WARNING The CS-2000DPII-TW2 LCD has a low battery warning system. When the battery volt

24 www.crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2007 Crimestopper Security Products

3 CONTROL MODULE & COMPONENT MOUNTING DO NOT Mount the control module in the engine compartment or where the wiring harness can b

4 WIRING BLACK WIRE: SYSTEM CHASSIS GROUND The Black wire MUST be connected to the CHASSIS METAL of the vehicle. Scrape away any paint or debris fr

5 WIRING BLUE/WHITE WIRE: NOT USED BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.) Connect to RED siren wire from the Siren in the engine compartment. W

6 WIRING: SHOCK SENSOR 4 PIN SENSOR PLUG/HARNESS (BLUE): White Wire: Negative Trigger Blue Wire: Negative Warn-away Black Wire: Sensor Ground Red Wi

7 POWER DOOR LOCK WIRING NEGATIVE TRIGGER DOORLOCK WIRINGPOSITIVE TRIGGER DOORLOCK WIRINGGREENGREENFUSEDRED+12VREDBLUE+BLUE8685868587873087A3087AFACT

8 DATA PORT DIAGRAM Data bus Systems: Data Controlled door locks, Factory Security and many accessories This unit includes DP Technology it will al

9 TRANSMITTER PROGRAMMING NOTE: All transmitters must be learned at the time of programming. This system can learn up to 4 remotes. 1. Turn key t