CrimeStopper CS-2004.TW1.I Betriebsanleitung PDF herunterladen (Seite 20)

CARJACK PROTECTION

PROGRAMMABLE PASSIVE CARJACK

This feature provides Passive Carjack protection and must be enabled before use through Alarm programming

options #7 & #12 on page 10. We recommend this mode should only be used in serious situations. When the

Ignition is on (vehicle is running), and a door is opened, then closed, the Carjack countdown sequence will

automatically be initiated. 60 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-

warning chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. To reset Passive

Carjack, IGNITION MUST BE ON, then press and hold the override button at least 5 seconds (or until flashing LED

shuts off).

SWITCH-CONTROLLED CARJACK PROTECTION (PINK WIRE CONFIGURATION)

NOTE: Carjack protection features using a switch on the PINK wire operate independently of programmable

protection methods listed above

Pink wire must be connected to a hidden toggle or momentary switch providing +12V. This configuration will enable

the vehicle owner to activate a Carjack countdown by pressing a designated toggle or hidden button (not included

with kit) during a Carjack situation. A Carjack countdown will begin under the following conditions: Ignition is ON

(vehicle is running), the button or toggle switch is pressed FIRST, and a door opens & closes. Upon these 3 events,

in that order, the alarm will start a Carjack countdown. After a 60 second delay, the system will begin chirping for 20

seconds then trigger into a full cycle for up to 5 minutes. To reset this Carjack mode, Ignition must be ON then

press and hold the override/program button 5 seconds until LED goes out.

ONLINE TECHNICAL SUPPORT

www.crimestopper.com/techweb03.html

www.crimestopper.com

Phone (800) 998-6880

FAX (805) 581-9500

1 2 ... 15 16 17 18 19 20

Keine Kommentare

CrimeStopper CS-2004.TW1.I Betriebsanleitung Seite 20