CrimeStopper CS-2001 Betriebsanleitung Seite 1

Stöbern Sie online oder laden Sie Betriebsanleitung nach Sicherheitszugriffskontrollsysteme CrimeStopper CS-2001 herunter. CrimeStopper CS-2001 Operating instructions Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
CS-2001
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security
Products Inc. This booklet contains the information necessary for installing, using, and maintaining your alarm
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the
Tech Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Siren,
L.E.D., Power, Ground, Doorpin, etc.
-OPTIONAL: These are features to be connected only if desired or agreed upon by the installing dealer (i.e.
Door Locks, Flashing Lights, Starter Kill, Hood, Trunk, and Auxiliary Remote Outputs etc.)
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
Seitenansicht 0
1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - CS-2001

CS-2001 REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Gargoyle™

Seite 2 - CONTROL MODULE MOUNTING

OPERATION PRE-WARNING SHOCK PROTECTION If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 6 quick siren

Seite 3 - COMPONENT MOUNTING

OPERATION DEFECTIVE ZONE ALERT/BYPASS If the system detects a faulty or open zone (Door left open) when the system is armed, the siren will chirp 4

Seite 5 - POWER DOOR LOCK WIRING

INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS,

Seite 6 - PROGRAMMING

COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the r

Seite 7

WIRING BROWN WIRE: (+) SIREN OUTPUT (2 Amp Max.) Connect to RED siren wire. BLUE WIRE: (-) HOOD/TRUNK TRIGGER This wire is an input trigger for a g

Seite 8

POWER DOOR LOCK WIRING 3 PIN DOOR LOCK PLUG (Optional): GREEN: (-) Negative pulse for LOCK RED: +12V Coil Power for external relays TERM 86. BLUE:

Seite 9

POWER DOOR LOCK WIRING PROGRAMMING DIP SWITCH PROGRAMMING There are 4 Dip switches under the access door on top of the control module for point of

Seite 10 - OPERATION

PROGRAMMING ELECTRONIC PROGRAMMABLE OPTIONS To change the electronic options turn the ignition on, wait at least (1) second, and press the override/

Seite 11 - CARJACK PROTECTION

PROGRAMMING OPTION DESCRIPTIONS (SEE CHART ON PG. 6) 10/60 Sec. DOOR OPEN WARNING This setting changes the delay time in which the alarm system beg

Seite 12

OPERATION 4 BUTTON REMOTE TRANSMITTER: #3#1TRANSMITTER BUTTONS#2#4PANICARMTRUNKPANICDISARM(LOCK)(UNLOCK)REMOTEPOP ACTIVE ARMING To arm the alarm an

Kommentare zu diesen Handbüchern

Keine Kommentare